When your garage door breaks down, it can cause a lot of stress. You may be worried about your safety and the security of your belongings. It can also be a huge inconvenience and cost. In some cases, it’s best to get a new garage door rather than repair the old one. However, in most cases you can fix your garage door yourself with a few simple repairs.
Before starting any major repairs or replacements, you should do a thorough inspection of your garage door. This will help you identify what the problem is and where to begin. In most cases, a broken garage door is caused by worn springs, so you’ll want to start there. The other major issue is rust. Rust can cause a door to stop working properly and can be very dangerous.
If you notice any signs of rust, you should spray it with a hose or wash it with a mixture of water and dish soap. You should also make sure that all of the tracks are clean and free from obstructions. Lastly, it’s a good idea to make sure that you have proper insulation for your garage to keep out bad weather, intruders, bugs and neighborhood animals like raccoons.
Taking before and after pictures is an important part of any DIY project. If you don’t take good before and after pictures, your project won’t look authentic or legitimate. This can damage your reputation and make you look incompetent or dishonest.
You should use a camera that can take clear, well-lit photos. You should also try to take the photos in a way that is similar to how the finished project will look. For example, if you’re doing an interior renovation, you should take the photos in a room that is similar to where the finished project will be located. This will ensure that the finished project looks like it was done in a professional setting.
A crooked or sagging garage door is typically indicative of a problem with the torsion springs. These are the springs that do all of the heavy lifting for your garage door, so it’s important to replace them when they break.
If the springs break, your garage door will be extremely difficult to open and close. It’s important to contact a Okotoks garage door repair service right away if you suspect your springs have broken. They can also perform an adjustment, motor cleaning and lube on your opener as well, which will save you time and money.
If you have a roll-up garage door, you should install a front mounting plank to which the rail bracket can be fastened. Locate the support at a location about two inches above the mark you made for your garage door’s high point and vertical center line. Secure the plank to the wall studs with lag screws. Then, center and fasten the rail to the plank, following the instructions in your kit.